You are here: Home > Hydronic Heater Replacement Parts > Teledyne Laars Heating System Parts > Rheos RHCH
Choose a sub category:
RHCH 1200 RHCH 2000 RHCH 1600
RHCH 2400
Teledyne Laars Rheos RHCH


Clickable Parts Diagram 1200

Clickable Parts Diagram 1600

Clickable Parts Diagram 2000

Clickable Parts Diagram 2400


RHCH Manual


(Acrobat Reader Required)
Sort By:
Page of 1
Teledyne Laars 10-332 Ignitor Gasket, CB/HWG Heatmaker 1-034 Bolt, Domestic coil, HW Laars 10-098 CABLE TIE, POLYPROPYLENE
Laars 10-332 Ignitor Gasket, CB/HWG

The igniter is a “glow bar” type silicon carbide unit. It is
energized whenever there is a call for heat and the red
"IGNITER" light on the boiler control is lit. After the igniter is
switched off and the boiler continues to run, the igniter functions
as a flame sensor for the boiler control.
If the ignitor fails and must be replaced, always install a new
igniter gasket with the replacement igniter.
CAUTION: Ignitor gets hot.
Heatmaker 1-034 Bolt, Domestic coil, HW Laars 10-098 CABLE TIE, POLYPROPYLENE
Teledyne Laars 10500900 COLLAR RING CONNECTOR
10500900 COLLAR RING CONNECTOR