You are here: Home > Hydronic Heater Replacement Parts > Teledyne Laars Heating System Parts > Rheos Plus RHHH
Choose a sub category:
RHHH 1200 RHHH 2000 RHHH 1600
RHHH 2400
Teledyne Laars Rheos (plus) RHHH


Clickable Parts Diagram 1200

Clickable Parts Diagram 1600

Clickable Parts Diagram 2000

Clickable Parts Diagram 2400


RHHH Manual


(Acrobat Reader Required)
Sort By:
Page of 1
Teledyne Laars 10-332 Ignitor Gasket, CB/HWG Teledyne Laars 10-216  BOLT,5/16-18x3/4 HEX HDSS Heatmaker 1-034 Bolt, Domestic coil, HW
Laars 10-332 Ignitor Gasket, CB/HWG

The igniter is a “glow bar” type silicon carbide unit. It is
energized whenever there is a call for heat and the red
"IGNITER" light on the boiler control is lit. After the igniter is
switched off and the boiler continues to run, the igniter functions
as a flame sensor for the boiler control.
If the ignitor fails and must be replaced, always install a new
igniter gasket with the replacement igniter.
CAUTION: Ignitor gets hot.
10-216  BOLT,5/16-18x3/4 HEX HDSS Heatmaker 1-034 Bolt, Domestic coil, HW
Laars 10-098 CABLE TIE, POLYPROPYLENE Teledyne Laars 10500900 COLLAR RING CONNECTOR
Laars 10-098 CABLE TIE, POLYPROPYLENE 10500900 COLLAR RING CONNECTOR