|
|
|
|
|
|
|
|
|
|
|
Teledyne Laars R0021300 Transformer, 40VA, 115/24V Kit, Rheos and Rheos+, 1200, 1600, 2000, 2400
|
Teledyne Laars RA0001200 125 PSI Pressure Relief Valve, 3/4" x 3/4", Previous Part #A0001200
|
LAARS RE2000300 Fuse Holder Kit (5 pack)
|
|
|
|
|
|
|
|
|
|
|
|
|
Teledyne Laars 10457000 Heat Exchanger Support Clip
|
Teledyne Laars S0079100 In/Outlet Header, Cast Iron, 2-pass
|
LAARS S0079200 Return Header, Cast Iron, 2-pass
|
|
|
|
|
|
|
|
|
|
|
|
|
TELEDYNE LAARS R2007700 On/Off Switch
|
Teledyne Laars L0061100 Main Burner, LoNox
|
Teledyne Laars V0077200 Gas Valve, Natural
|
|
|
|
|
|
|
|
|
|
|
|
|
Teledyne Laars E0214600 Switch, Air Pressure, Diaphragm
|
Honeywell L4008E1271 High Limit, Manual Reset, PNCH
|
Raypak 052870F Deliming 7/8" Tube Kit
|
|
|
|
|
|
|
|
|
|
|
|
|
LAARS 10579105 Cupronickel Tube Assembly, w/gaskets, 400
|
Teledyne Laars W0038001 Ignitor & Gasket kit, Mighty Therm LoNox
|
Teledyne Laars R20607600 Pump housing Kit, Mighty Therm 500-1825, Pennant 500-2000
|
|
|
|
|
|
|
|
|
|
|
|
|
LAARS R0095505 Copper Tube Assembly w/gaskets, 400
|
Teledyne Laars RE0015900 High Limit Kit, E0015900
|
Laars 10-332 Ignitor Gasket, CB/HWG
The igniter is a “glow bar” type silicon carbide unit. It is energized whenever there is a call for heat and the red "IGNITER" light on the boiler control is lit. After the igniter is switched off and the boiler continues to run, the igniter functions as a flame sensor for the boiler control. If the ignitor fails and must be replaced, always install a new igniter gasket with the replacement igniter. CAUTION: Ignitor gets hot.
|
|
|
|
|
|
|
|
|
|
|
|
|
Teledyne Laars S0076500 Gasket, Flange
|
TELEDYNE LAARS 10451200
|
Teledyne Laars A0110200 Blower, 115/230 volt, single in/out
Used on the following C-Boiler LoNox Models:
HH0250, HH0400, PH0250, PH0400, PW0250, PW0400.
|
|
|
|
|
|
|
|
|
|
|
|
|
10447100 HDR BAR,MACH,9-TUBE,ASME
|
10447200 HEADER BAR,MACH,9-TUBE
|
Laars 10452405 TUBE ASSY,CU(THK WALL)400
|
|
|
|
|
|
|
|
|
|
|
|
|
Teledyne Laars E0109200 Switch, Previous Part #E2104300
|
LAARS E0025900 Non-Plated Immersion Well
|
TELEDYNE LAARS RE2058300 Immersion Well Kit (nickel plated), Rheos and Rheos+, 1200, 1600, 2000, 2400
|
|
|
|
|
|
|
|
|
|
|
|
|
LAARS 10535205 Top Filler Plate, 400
|
LAARS R10261501 Pump Housing, Glass-Lined Cast Iron
|
Teledyne Laars 10462200 Insulation and Retainer, All
|
|
|
|
|
|
|
|
|
|
|
|
|
Teledyne Laars E0223400 Wire Harness, 5", 26" Red
|
10448302 GAP CLOSURE, RETURN SIDE
|
LAARS RA0079000 Temperature & Pressure Gauge
|
|
|
|
|
|
|
|
|
Teledyne Laars RQ0078800 Venturi Tubing/Fittings Service Kit
|
|